Operation method of electric chainsaw
Operation method of electric chainsaw
1, when the processing of the original belt distance conveyor 1. No operation is allowed within 5m.
2. Before switching on the power supply, the chainsaw switch must be turned off to prevent accidental startup.
3. Start the chain saw idling for 1min before making the material, and check whether the operation is normal.
4. When starting or operating, hands and feet shall not be close to the rotating parts, especially the upper and lower parts of the chain
5, when the fuse or relay trip, should be immediately checked.
6. No overload work on the circuit, no access to high-capacity fuses.
You must operate the chain saw with both hands.
8, the operation must stand, do not stand under the original or log and may roll on the original or log operation.
9. Special attention should be paid to the safety of auxiliary personnel when removing the clamping saw fault.
10. Lubricate and cool the sawing mechanism at any time during operation.
11, when the original blade is about to be cut, should pay attention to the trend of wood, saw quickly after the chain saw.
12, transfer the operation must first turn off the chainsaw switch, transfer is not allowed to run.
Chain saws are not allowed to operate under the following conditions.
When someone approaches
2. Before the auxiliary staff of materials are evacuated to a safe area;
3. The original article in the operation area is not stowed stably;
4. Insufficient light;
5. In rainy days, the wind is stronger than level 5 and the open ground with thunder and lightning;
6, no broken chain protection and rebound protection device, or device damage.
At the end of the assignment
All nuts, bolts and screws shall be tightened after daily operation to check the wear degree of chain saw, guide plate and sprocket, and make necessary adjustment and replacement.
Check the power plug and cable insulation layer wear, found damaged should be replaced or repaired in time.
Before long-term storage, clean up residual wood chips and dirt, remove the saw chain and guide plate and apply anti-rust oil, and the motor should be dust protection.
Should be stored in a dry environment.
1, when the processing of the original belt distance conveyor 1. No operation is allowed within 5m.
2. Before switching on the power supply, the chainsaw switch must be turned off to prevent accidental startup.
3. Start the chain saw idling for 1min before making the material, and check whether the operation is normal.
4. When starting or operating, hands and feet shall not be close to the rotating parts, especially the upper and lower parts of the chain
5, when the fuse or relay trip, should be immediately checked.
6. No overload work on the circuit, no access to high-capacity fuses.
You must operate the chain saw with both hands.
8, the operation must stand, do not stand under the original or log and may roll on the original or log operation.
9. Special attention should be paid to the safety of auxiliary personnel when removing the clamping saw fault.
10. Lubricate and cool the sawing mechanism at any time during operation.
11, when the original blade is about to be cut, should pay attention to the trend of wood, saw quickly after the chain saw.
12, transfer the operation must first turn off the chainsaw switch, transfer is not allowed to run.
Chain saws are not allowed to operate under the following conditions.
When someone approaches
2. Before the auxiliary staff of materials are evacuated to a safe area;
3. The original article in the operation area is not stowed stably;
4. Insufficient light;
5. In rainy days, the wind is stronger than level 5 and the open ground with thunder and lightning;
6, no broken chain protection and rebound protection device, or device damage.
At the end of the assignment
All nuts, bolts and screws shall be tightened after daily operation to check the wear degree of chain saw, guide plate and sprocket, and make necessary adjustment and replacement.
Check the power plug and cable insulation layer wear, found damaged should be replaced or repaired in time.
Before long-term storage, clean up residual wood chips and dirt, remove the saw chain and guide plate and apply anti-rust oil, and the motor should be dust protection.
Should be stored in a dry environment.